Différences

Ci-dessous, les différences entre deux révisions de la page.

--- domotique:smart_connect_plug [2023/02/26 12:36] – ptitfrap
+++ domotique:smart_connect_plug [2023/02/26 13:09] (Version actuelle) – ptitfrap
@@ Ligne 1: / Ligne 1: @@
 ===== LSC Smart Connect Power Plug =====
+Prise LSC Smart Connect Power Plug Smart
+Art. nr. 2578677
 Install Docker
@@ Ligne 12: / Ligne 16: @@
   sudo ./tuya-cloudcutter.sh
+Vérifier
+  [!] WARNING: Selected wifi AP support: oui
-[[https://github.com/tuya-cloudcutter/tuya-cloudcutter]]
+Choose
+) Flash 3rd Party Firmware
-[[https://github.com/tuya-cloudcutter/tuya-cloudcutter.github.io/tree/master/devices]]
+Select Firmware, normally only one.
-.1.8 BK7231T / oem_bk7231s_rnd_switch and SS01S Single Pole Smart Light Switch (TreatLife)
+Choose
-  PINs
+  By firmware version and name
-  As this is a very basic plug, there is not much configuring.
-  PIN6 LED_n 1
+Select
-  PIN7 Btn 1
+  > 1.1.8 - BK7231T / oem_bk7231s_rnd_switch
-  PIN8 Rel_1 1
+  > TreatLife
-  PIN26 Wifi
+  > SS01S Single Pole Smart Light Switch
+Press Power Button for > 5sec once, blinking fast then press again for >5sec.
+Then when asking to do it again, redo the same twice long press(Can be quite long)
+  Scanning for open Tuya SmartLife AP
+Wait for Fimware Flash Complete.
+Then connect to Wifi, then browse http://192.168.4.1/ and config
+  #Configure Name
+  #Configure Wifi
+  # Configure Module
+  P6 (PWM0) LED 0
+  P7 (PWM1) Btn 0
+  P8 (PWM2) Rel 0
+  P26 (PWM5) WifiLED
+  # Configure General/Flags
+  Flag 6 - [BTN] Instant touch reaction instead of waiting for release (aka SetOption 13)
+[[https://github.com/tuya-cloudcutter/tuya-cloudcutter]]
+[[https://github.com/tuya-cloudcutter/tuya-cloudcutter.github.io/tree/master/devices]]
 [[https://www.elektroda.com/rtvforum/topic3943688.html#20350582]]